COMPACT COMMERCIAL ELECTRIC WATER HEATER
- 3-Year Limited Warranty* on Tank
Heavy-gauge steel is automatically formed, rolled and welded to assure
continuous seams for ceramic lining. Each tank is triple tested to ensure
quality.
- 1-Year Limited Warranty* on Parts
- Fused Ceramic ShieldTM
A tough, thick durable coat of blue cobalt ceramic is fused to the tank's
interior surfaces at 16000F, forming a corrosion-resistant
lining for years of dependable protection and use.
- Non-CFC Foam Insulation
The tank is surrounded by a thick coat of non-CFC polyurethane foam
to trap heat inside the tank, saving energy.
- Heating Element
Screw-in, direct immersion, 1500 watt, 120 volt heating element for
maximum efficiency. Available in other wattages and voltages for every
job.
- Dip Tube (6U and 12U Models)
Carries cold inlet water deep into the tank to minimize temperature
dilution of hot water. On 6- and 12-gallon only.
- T&P Valve
Conveniently located on the side of the tank to facilitate piping to
a drain or external to the building.
- 3/4" Water Connections
Located on top. 6- and 12-gallon models are top or side connect; 20-gallon
model is side connect only.
- Anode Rod
Top-mounted, heavy duty anode for added tank protection, extending the
life of the tank.
- Built-in Electric Junction Box
Top-located, convenient junction box, ready for 1/2" conduit.
- Thermostat/High Limit Control
Single-element thermostat adjustable to 170oF with high limit
for single-element heaters.
- Code Approvals
Listed to UL 174, 1990 NAECA approved. All models are certified at 300
PSI test pressure and 150 PSI working pressure.
- Drain Valve
Non-metallic, corrosion-free drain valve.
Limited warranty on tank and parts. Complete details in manual. Specify
wattage, vollage and phase when ordering.
SPECIFICATION
Commercial electric water heater(s) shall be model ________________ as
manufacturered by American Water Heater Company, or an approved equal,
and shall have a 3-year tank warranty and a 1-year parts warranty, installed
in a commercial application. Heater(s) shall have a storage capacity of
______ gallons and shall have a rated input of ______ KW at ______ Volts,
single-phase, 60/50 cycle AC, and shall be design certified, tested and
listed in accordance with Underwriter's Laboratories Standard UL 174.
Heaters shall meet or exceed the requirements of the Federal "National
Appliance Energy Conservation Act of 1987" and shall comply with
ASHRAE Standard 90.1b-1992. The interior of the storage tank shall be
lined with a Fused Ceramic ShieldTM lining, fused to the tank
at 1600oF, forming a corrosion-resistant lining; polymer linings
are not acceptable. Each tank shall be funished with an internal anode
for anoic protection. The unit must be equipped with a built-in electrical
junction box. Electrical heating element shall be screw-in, direct immersion,
resistance type. Element operation shall be controlled by a thermostat
adjustable to 170oF. A high-temperature cutoff shall be supplied
as an intergal part of the heater. Element access panel shall be provided
on the front of the heater for each element. A corrosion-resistant drain
valve shall be provided on the front of each unit. The tank shall be totally
encased in a metal jacket and insulated with non-CFC foam to reduce standby
heat loss. The tank must be design certified for 300 PSI test pressure
and 150 PSI working pressure.
|
