| 110-14 (截止阀)/ 1110-14 (角阀)
浮子控制阀 - 开/关(启/闭)调节高/低液位
110-14 (Globe) / 1110-14 (Angle)
FLOAT CONTROL – ON/OFF (OPEN/CLOSE) ADJ. HI/LO LEVEL
当液位达到预先设置的低点时,ACV 110-14完全开启,而当达到预先设置的高点时,则实现零泄漏关闭。所配置的旋转3端口引导配置垂直杆,使得浮子能够上升和下降以调节上部和下部停止点。
The ACV 110-14 opens fully when the level reaches
the preset low point and shuts off drip tight when the high level is reached.
The rotary 3-port pilot is equipped with a vertical rod which allows the
float to rise and lower to the adjustable upper and lower stops.
注: 除非指定在阀门上安装,否则引导装置都是远程安装的。标准配置是黄铜杆和塑料浮子。DN50 - DN150的阀门标准配置是2
- 12英寸杆。DN200 - DN400阀门标准配置是4 - 12英寸杆。可提供不锈钢杆和浮子。如果水面出现动荡、波纹或风,则在浮子周围应该安装一个静水井。
NOTE:
The pilot is remote mounted unless specified valve mounted. Standard equipped
with brass rods and plastic float. Valve 2-6" standard with 2-12" rods.
Valves 8-16" standard with 4-12" rods. Stainless steel rods and float
are available. Provide a stilling well around float if liquid surface
is subject to turbulence, ripples or wind.
指定: 如果需要,可以在阀门上安装引导装置,阀门也可水平或垂直排放。
SPECIFY:
Valve mounted pilot is required, and valve discharge horizontal or vertical.
快速选型:阀门通径与注入管口径相同或小一个等级。
QUICK SIZING: Valve
size same as fill line or one size smaller.
需要考虑的因素
Points to consider:
- 最小压差为5 psig
Minimum differential pressure 5 psig
- 参阅技术参数 - 流量表
Refer to Engineering Data – Flow Capacity Chart
- 进口压力与容器排放压力比较
Inlet pressure vs. tank head pressure
- 所需流量的压降
参阅技术参数 - 压降表
Pressure drop at required flow
Refer to Engineering Data – Pressure Drop Chart
- 如果阀门通径比管道口径小,则考虑采用ACV 6110-14。咨询美国瓦茨ACV销售代表/工厂。
If valve size is smaller than line size, consider
ACV 6110-14. Consult Watts ACV representative/factory
|