110-10 （截止阀）/ 1110-10 （角阀）
浮子控制阀 - 调节（恒定水位）
110-10 (Globe) / 1110-10 (Angle)
FLOAT CONTROL – MODULATING (CONSTANT LEVEL)

　　ACV 110-10在储液罐或蓄水池内保持恒定水位。阀门按比例排放控制进入储液罐或蓄水池内的流量，保持储液罐或蓄水池处于满的状态。
　　The ACV 110-10 maintains a constant level in storage tanks and reservoirs. Valve controlled flow into the tank is proportional to discharge flow, keeping the tank full.

　　注：这种调节浮子控制阀ACV 10-11，是远程安装的。如果水面出现动荡、波纹或风，则在浮子周围应该安装一个静水井。
　　NOTE: The modulating float control ACV 10-11, is remote mounted. A stilling well around the float should be installed if the liquid surface is subject to turbulence, ripples or wind.

　　快速选型: 阀门通径与注入管道相同；或当排泄管道口径比注入管道口径小时，阀门通径要比注入管道口径小。要使得阀门通径/能力与排放要求相适应。
　　QUICK SIZING: Valve size same as fill line or one size smaller if discharge line is smaller than fill. Match size/capacity to discharge requirements.

需要考虑的因素
Points to consider:

• 最小压差为5 psig
  Minimum differential pressure 5 psig
• 参阅有关最大流量的表格
  Refer to table for maximum flow
• 进口压力与容器排放压力的比较
  Inlet pressure vs. tank head pressure
• 所需流量的压降
  参阅技术参数 - 压降表
  Pressure drop at required flow
  Refer to Engineering Data – Pressure Drop Chart
• 如果要求阀门通径比管道口径小，则考虑采用ACV 6110-10。咨询美国瓦茨ACV销售代表/工厂。
  If valve size required is smaller than line size, consider ACV 6110-10. Consult Watts ACV representative/factory

流向显示：在阀座下方
选项‘R’，从阀座上方流动
Flow Direction Shown: Under the Seat
Optional ‘R’ Flow Over the Seat:

关闭阀门 开启阀门 CLOSES VALVE OPENS VALVE